TRC is primarily funded by ad revenue. If you like the content you find here, don't block the ads check them out instead. Thank you.
Results 1 to 3 of 3

Thread: Is this kiln 1 phase or 3 phase?

  1. #1
    Should Get Out More
    Join Date
    Dec 2007
    Location
    london
    Posts
    6,814
    Like
    8
    Liked 45 in 34 posts

    Default Is this kiln 1 phase or 3 phase?


    TRC is primarily funded by ad revenue. If you like
    the content you find here, don't block the ads check
    them out instead. Thank you.
    I can’t really make out the pic of the plate. An anyone help? I’m assuming as 5.5 kw then 6mm^2 cable with 32 MCB would be able to run it (like an oven). For home use.

    https://www.ebay.co.uk/itm/Pottery-K...UAAOSwS5Na8AYf


  2. TRC is primarily funded by ad revenue. If you like the content you find here, don't block the ads check them out instead. Thank you.
  3. #2
    Should Get Out More Big Pete's Avatar
    Join Date
    May 2008
    Location
    Ilkeston
    Posts
    7,893
    Like
    1,584
    Liked 1,095 in 642 posts

    Default Re: Is this kiln 1 phase or 3 phase?

    it will do either, on 3 phase you need three phase lines plus neutral, so a 4 wire system (you can also do 5 wire three phase that has a separate earth). On single phase it's going to draw a lot of amps, 23 on 240V so you will likely need to hardwire it to the fuse box.

  4. #3
    Should Get Out More
    Join Date
    Dec 2007
    Location
    london
    Posts
    6,814
    Like
    8
    Liked 45 in 34 posts

    Default Re: Is this kiln 1 phase or 3 phase?

    Ok thanks. Yeah so I’m imagining running a direct 6mm cable straight to spare on fuse box with 32amp breaker.

Go Back to Forum My Forum