TRC is primarily funded by ad revenue. If you like the content you find here, don't block the ads check them out instead. Thank you.
Page 6 of 6 FirstFirst ... 456
Results 76 to 79 of 79

Thread: Another ratty old shed project that will take years to finish. GPz550

  1. #76
    Should Get Out More chillitt's Avatar
    Join Date
    Jan 2008
    Location
    Gloucestercestershire
    Posts
    12,918
    Like
    3,013
    Liked 4,731 in 2,313 posts

    Default Re: Another ratty old shed project that will take years to finish. GPz550


    TRC is primarily funded by ad revenue. If you like
    the content you find here, don't block the ads check
    them out instead. Thank you.
    Quote Originally Posted by 1888 View Post
    I never used blanking plates. I just put a bolt in the top of the AD unit so i could keep the look. You will be lucky to find another front end that fits due to the skinny stanchions. I had the same problem as the 750 was something daft like 37mm. Measure yours. If the same as 750 i may have a set still in the loft. Unsure of condition. Another idea could be the whole front end get the stem pressed out the bottom yoke and pressed into the donor front end. This will allow it to slide straight in. This was a common swap using a zxr6 front and back end

    35mm I have a spare 900R front end which looked promising but its way too wide and the 16 inch wheel would upset things and look silly.

  2. #77
    Should Get Out More 1888's Avatar
    Join Date
    Mar 2010
    Location
    JockLand
    Posts
    26,783
    Like
    864
    Liked 2,787 in 1,996 posts

    Default Re: Another ratty old shed project that will take years to finish. GPz550

    Forgot you got that 900R. Get the bits on ebay of good as they can pull good money now. Few forks for your bike on there now also.

  3. #78
    Should Get Out More
    Join Date
    Dec 2007
    Location
    A windswept Hebridean paradise.
    Posts
    22,175
    Like
    1
    Liked 4,156 in 2,382 posts
    Blog Entries
    8

    Default Re: Another ratty old shed project that will take years to finish. GPz550


  4. The following user liked this post made by cheb:


  5. #79
    Should Get Out More chillitt's Avatar
    Join Date
    Jan 2008
    Location
    Gloucestercestershire
    Posts
    12,918
    Like
    3,013
    Liked 4,731 in 2,313 posts

    Default Re: Another ratty old shed project that will take years to finish. GPz550

    Quote Originally Posted by cheb View Post
    According to that 900R stem is the same...

Page 6 of 6 FirstFirst ... 456
Go Back to Forum My Forum

TRC Affiliates - Help TRC make a small amount of commission